After Each Use; Using For The First Time; Maintenance And Care - Viper AS430C-US User Manual

USER MANUAL
downward (B, Figure 8), and then twist open the drain cap to
drain the wastewater in the tank. After draining is completed,
rinse the inside of recovery tank with clean water
CAUTION
！ ！ ！ ！
When draining the wastewater, the drain hose must
be folded or lowered to a lower position (Figure 8 A
or B), and the cap removed for wastewater to drain.
Do not allow the opening of the drain hose to face
upward, as it could get wastewater on the
Solution tank emptying
6. Complete Steps 1 to 4.
7. As shown in Figure 9, turn open the lid of Solution tank (A) counter
clockwise (direction C), to drain Solution tank completely. Use
clean water to rinse the inside of Solution tank. When work is
completed, replace the solution tank lid (A) by twisting in a
clockwise in direction (B).

AFTER EACH USE

When work is done and before leaving the machine, completes the
following steps:
1. Remove the brush / pad holder.
2. Drain solution tank & rinse with clean water.
3. Drain recovery tank & rinse with clean water.
4. Complete the daily maintenance procedures. (see maintenance
section)
5. Remove and rinse squeegee assembly with damp towel.
6. Keep recovery tank lid unsealed from tank to allow fresh air to
circulate freely

USING FOR THE FIRST TIME

After the first 9 hours of use, please check components to ensure all connections (electrical &
mechanical) are tight & check for any damage that may have occurred during operation. Check for
water leakage.

MAINTENANCE AND CARE

The service life and the maximum operation safety of the machine are assured by proper and timely
maintenance and care.
The following table is a routine maintenance guide for the machine. The time intervals of
maintenance are determined to a large extent by the working conditions of the machine. These time
intervals should be formulated by the person responsible for the maintenance.
WARNING
！ ！ ！ ！
Only after the main power is disconnected should these procedures be performed.
Prior to proceeding with any of the maintenance procedures, please study carefully
the related safety sections.
All maintenance should be done by qualified personnel or authorized Viper service centers.
This manual only relates the simplest and the most common maintenance procedures.
For any maintenance procedures other than those stated in this table of planned maintenance,
please contact your local Viper distributor.
operator..
8
Figure 8
Figure 9