Use and maintenance
Operating guidelines AS4335C
Remove the red cover, fill the tank 1/2 full, then
add an appropriate amount of low foaming
detergent. Complete the filling of the tank,
and replace the red cover.
Install the brush or pad holder onto the drive plate
and give a slight clockwise turn. Lower the brush
deck by pressing the pedal down and to the right.
Either of the red safety switches can be used
to operate the machine. The handle height can
be raised and lowered using the black lever on
the handle.
When scrubbing is complete, turn off the machine
to perform the following maintenance.
July 2020
You can check the level of the solution anytime
using the red ball on the left side of the machine.
Connect the power cord to a 3-prong grounded
electrical outlet. Press the machine ON button.
Lift the squeegee up by hand until it locks in the
UP position, and turn off the vacuum, to perform
double scrubbing.
To return to normal working mode, use the red
lever to release the squeegee, and turn the vacuum
back on.
Lift the deck and squeegee by pressing the pedal
down and to the left.
Press the solution and vacuum ON and start
cleaning by placing your hands on either of
the safety switches.
Solution flow can be adjusted to the scrubbing
need by adjusting the manual valve located near
the solution filter.