Machine Operation (Scrubbing And Drying); Tank Emptying - Viper AS430C User Manual

ENGLISH
Turning off the machine
7. When you have finished using the machine, first unload the brush/pad-holder (refer to the steps
related in the section on brush/pad-holder installation and
unloading)
8. Release the safety switch (1) to turn off the brush/pad-holder
and solenoid valve.
9. 9. Press the Vacuum pump switch (39) to the "O" position,
and the Vacuum pump will delay for 5 seconds before
stopping work.
10. 10. Press the water flow volume control switch (40) to the "O"
position to completely turn off the work of solenoid valve.
11. Press the power switch (38) to the "O" position. And
disconnecting the power cable (9) from the power supply.
12. Use the squeegee lifting handle (14) to lift the squeegee.
13. Grasp the handlebar (2) and gently tilt the machine backward
until the guide wheel (B) touches the floor. See Figure 7.

MACHINE OPERATION (SCRUBBING AND DRYING)

1. Start the machine according to the description above.
2. Hold the safety switch (1) (according to the way shown in Figure 6), push to move the machine,
and start the cleaning job.
3. If necessary, turn off the machine, and adjust the regulating handle of the squeegee. (Refer to
the steps for adjusting the balance of the squeegee)
4. If necessary, turn off the machine, and adjust the volume of water flow with the ball valve handle.
(Refer to the steps of adjusting volume of water flow.)
CAUTION！
In order to avoid damaging the floor, when the machine stays in one place without
moving, please turn off the power switch (38).

TANK EMPTYING

When recovery tank is full, a float in the automatic float turn-off device (36) will block the inlet
connecting to the vacuum pump. Through a sudden increase of noise from the vacuum pump, it can
be considered that the vacuum pump is already overloaded and an immediate draining of the
wastewater is needed.
CAUTION！
If the vacuum motor is suddenly turned off (e.g. because the machine is suddenly
moved resulting in an activation of the float), and if a resumption of operation is
needed, please perform the following steps: press the power switch (38 and 39) to
turn off the power and the vacuum motor, and open the recovery tank cover (25) to
check if the float in the float filter has returned to the water surface.
recovery tank cover (25), and press the power switch (38 and 39) to turn on the
power and the vacuum motor.
When the recovery tank is fully filled with wastewater, follow the
following steps to drain it all.
Recovery tank emptying
1. Turn off the machine.
2. By using the squeegee handle (14), lift the squeegee.
3. Move the machine to a dedicated dump site.
4. Grasp the handlebar (2) and gently incline the machine
backward until the guide wheel touches the floor. (For docking
of the machine please refer to the procedures in the stopping of
the machine section.)
5. Take off the draining hose from the fixation clip, bend the top
end of draining hose (as shown in A, Figure 8), and then open
the cover of draining hose, lower draining hose to a low level or on the ground to drain the water.
8
USER MANUAL
VF90015-EU
Figure 7
Then close
Figure 8