IBM 9006-22P Servicing page 46

Figure 27. Inserting adapters into the riser
5. Replace the drive signal cables (A) and (B) into the rear of the disk drive backplane as shown in Figure
28 on page 32. Replace the drive power cable (C) into the disk drive backplane.
Figure 28. Connecting the drive signal cables the drive power cables to the disk drive backplane
6. Using your labels and locations, connect the drive signal cables (B) and (C) to the system backplane as
shown in Figure 29 on page 33. Connect the drive power cable (A) to the system backplane.
Using your thumb, press the release latch on the connector to unplug the cable.
32 Power Systems: Servicing the 9006-22P