Table of Contents
Advertisement
HOW TO CONNECT YOUR HOME STEREO
Note: If your stereo has an unused LINE OUT jack,
see instruction A below. If the LINE OUT Jack is
being used, see instruction B.
A. Plug one end of the audio cable into the jack on the
front of the treadmill near the power cord. Plug the
other end of the cable into the included adapter.
Plug the adapter into the LINE OUT jack on your
stereo.
A
II
v
• ........
*°..°.
_.°°°.....o.._I.°Z
i'_'_]
Audio
Adapter--_
i"-"
v
i
Cable
B. Plug one end of the audio cable into the jack on the
front of the treadmill near the power cord. Plug the
other end of the cable into the included adapter.
Plug the adapter into an RCA Y-adapter (available
at electronics stores). Next, remove the wire that is
currently plugged into the LINE OUT jack on your
stereo and plug the wire into the unused side of the
Y-adapter. Plug the Y-adapter into the LINE OUT
jack on your stereo.
a
_
._=
i....°°°°o°_
'
:O...1--i
b, .
RCA
f J_']'_i
Audio
Y-adapteT
i_'F_
i
CabLe
Adapter
Wire removed from
LINE OUT jack
HOW TO CONNECT YOUR COMPUTER
Note: If your computer has e 3.5mm LINE OUT jack,
see instruction A. If your computer has only a
PHONES jack, see instruction B.
A. Plug one end of the audio cable into the jack on the
front of the treadmill near the power cord. Plug the
other end of the cable into the LINE OUT jack on
your computer.
A
! _
_
i
Cable
W
"--:.":_':
=
=
--
B. Plug one end of the audio cable into the jack on the
front of the treadmill near the power cord. Plug the
other end of the cable into a 3.5mm Y-adapter
(available at electronics stores). Plug the Y-adapter
into the PHONES jack on your computer. Plug your
headphones or speakers into the other side of the
Y-adapter.
B
II
w
Headphones/S
16
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 520X and is the answer not in the manual?
Questions and answers
I want to get the base off of the ProForm 520x, and get it out of my basement. It does not work.So basically disassemble for moving purposes.
To disassemble the Pro-Form 520X treadmill for moving, follow these steps:
1. Lower the Incline: Adjust the treadmill to the lowest incline position to prevent damage.
2. Unplug the Power Cord: Disconnect the treadmill from the power source.
3. Fold the Treadmill:
- Hold the treadmill at the designated locations.
- Bend your legs and keep your back straight to avoid injury.
- Lift the treadmill using your legs.
- Move your right hand to the appropriate position and hold firmly.
- Use your left hand to pull the latch knob to the left and hold it.
- Raise the treadmill until the catch passes the latch pin.
- Slowly release the latch knob, ensuring the catch is securely held by the latch pin.
4. Protect the Floor: Place a protective material under the treadmill to prevent floor damage.
These steps allow you to safely prepare the treadmill for moving.
This answer is automatically generated