Table of Contents
Advertisement
DEXEN - Gas Conversion Part C - Dexen IPI Regulator Solenoid Conversion Kit
LPK-DXF & NGK-DXF
1. Before starting, turn the gas supply and power OFF.
2. With a tamper proof T20 Torque Driver remove two screws identified as A & B in figure 1 & 2 from the regulator
solenoid assembly.
3. Remove and discard the regulator solenoid assembly and gasket from valve body.
4. Remove protective plastic cover.
5. Install new gasket into the gasket groove and the regulator solenoid assembly onto the valve.
6. Replace screws and tighten down. DO NOT overtighten, as this could result in damaged threads and cause
leakage.
7. Using a leak detector or soapy solution, check for leaks while valve is in operation.
8. Using the label provided in your kit, place the label on the valve.
WARNING: This modulating conversion kit must only be applied as part of a conversion kit supplied by the
appliance Manufacturer for the specific appliance, and type of gas being converted.
INSTALLER NOTICE: These instructions must be left with appliance.
LPK-DXV & NGK-DXV
ALL WORK MUST BE PERFORMED BY A
CERTIFIED GAS TECHNICIAN
Installation Instructions
49
Advertisement
Table of Contents
