Maintenance And Repair; Maintenance; Repair; Product Disposal - WAGNER GM5000 Operating Manual

EDITION 03/2012
OPERATING MANUAL
8

MAINTENANCE AND REPAIR

8.1

MAINTENANCE

The functionality and completeness of the control unit have to be checked regularly.
All sealed elements in the control device must be available and undamaged. During
operation, all electric connections in the control unit and relevant plug connectors or
shut-off devices have to be tightly sealed.
The leak tightness of the unit has to be checked every 3 years at least. The „Gas-proof"
requirements according to DIN EN 60079-15:2011 have to be fulfi lled. This inspection may
only be carried out by an authorized person or by trained Wagner Service personnel. The
mains input terminal shall serve as the test port in the leak-tightness check.
8.2

REPAIR

Repairs to the control unit may only be carried out by trained Wagner Service personnel.
This also includes opening the control unit.
After a successful repair, the seal tightness of the control unit has to be checked.
The „Gas-proof" requirements according to DIN EN 60079-15:2011 have to be fulfi lled.
The mains input terminal shall serve as the test port in the leak-tightness check.
Sparking by separation and joining of live construction units!
Danger of explosion by electrical sparks
SIHI_0144_GB
9

PRODUCT DISPOSAL

Do not dispose of waste electrical equipment with the house-
hold refuse!
In accordance with European Directive 2002/96/EC on the disposal
of waste electrical equipment and its implementation in national
law, this product may not be disposed of with the household refuse,
but must rather be recycled in an environmentally correct manner.
Your waste Wagner electrical device will be taken back by us or our
representatives and disposed of environmentally correctly. Please
contact one of our service points or one of our representatives or us
directly to this purpose.
SIHI_0127_GB
PART NUMBER DOC 2318724
WARNING
Disconnect connectors not under tension.
Fuse holders under tension do not open.
Remove the service plug cover not under tension.
Note
VM 500
25