ADTEK CS2-TM User Manual page 12


PROGRAMMING LEVEL
ENT
ENT
Correct?
NO
YES
▼
▲
INPUT
GROUP
PRESS
TO ENTER

INPUT GROUP
ENT
F N
▼ ▲
▼ ▲
Next P.
DESCRIPTION
MEASURING PAGE
PASS CODE PAGE
Enter the pass code to get into
programming level.
Press for 1 second to back Measuring Page
▲
▼
▲
RELAY
GROUP
INPUT GROUP
PRESS
TO ENTER
DESCRIPTION
INPUT GROUP INDEX
Pv.bSE: Time unit of Immediate
Value(PV);
Please refer to the specification and
output of flowmeter, and then set the time
base.
The defference mode selected will show
up relative parameters following
F.tYP: Flow Rate type;
There three three types setting for
Pulse/Flow-unit(K factor), Flow/Pulse(1/K
factor) and Flow rate/Hz to match the
difference output description of
flowmeters. Engineer needs just to
check the mode of flowmeter and
setting. The totalizer will calculating the
flow rate, and accumulation.
If user wants to change the
pass code, please go to step
A-20 to set. Please remind the
new pass code.
▼
▲
EXTERNAL
CONTROL
PRESS
TO ENTER
In following page, press
INPUT GROUP INDEX.
Selectable: 1/SEC 1/Min 1/Hour
1/dAY
1/SEC: Flow/Second
1/Min: Flow/Minute
1/Hour: Flow/Hour
1/dAY: Flow/Day
Up
Selectable: PLS/F F/PLS
d.MUL.v
PLS/F:Pulse/Flow(K Factor);
F/PLS:Flow/Pulse(1/K Factor);
d.MUL.v: πr
Up
12 / 27
PARAMETERS
▼
▼
▲
ANALOGUE
OUTPUT
GROUP
PRESS
TO ENTER
PARAMETERS
for 1 second to back
Down Enter
Settable the decimal point
of Pulse/Flow(K Factor)
and Pulse/Flow(K Factor)
Settable the decimal
point of Flow/Pulse(1/K
Factor) and
Flow/Pulse(1/K Factor)
2
x Flow Speed;
Settable the decimal
point of diameter of pipe,
flow speed and F
diameter of pipe, flow
speed.
Down Enter
CS2-TM(Pulse)-Operating Manual 2012-05-10
RS485
GROUP
PRESS
TO ENTER