Table of Contents
Advertisement
Insinger Model 45SA5
6.2.1.4
Replace strainer assembly and tighten the large hex
nut.
6.2.1.5
Open the rinse water shut-off valve.
6.2.1.6
Operate the machine through a cycle.
During the
rinse phase, adjust the rinse water pressure to 20 psig.
6.2.2
Removal and replacement of electric tank heater. See
Figure 6-2.
6.2.2.1
Turn off dishwasher power at the main disconnect
switch.
6.2.2.2
Drain the wash tank per 2.4.3.
6.2.2.3
Remove the external heater cover and disconnect the
three power wires.
Save the paper insulating strip.
Disconnect the electrical conduit.
6.2.2.4
On the inside of the wash tank, remove the 2 hose
clamps that hold the high temperature limit switch capillary
to the heater element and move the capillary to the side.
Loosen and remove the large brass hex nut from the heater
body and withdraw the heater from the tank.
6.2.2.5
Clean the tank hole and install a new heater, brass
washer, and gasket in the tank hole.
Use plumber's putty
between the large brass hex nut and the inside of the tank.
Install and tighten the large brass nut from the inside of
the tank.
Clamp the capillary to the UPPERMOST heater
element.
6.2.2.6
Reconnect the power wires and conduit and replace
the paper insulating strip and heater cover.
6.2.3
Removal and replacement of thermometers.
6.2.3.1
If a thermometer is suspected of being defective,
first check the unit against a reference thermometer and
compare readings.
Tolerance is plus or minus 2° F.
6.2.3.2
To remove the wash thermometer, first turn the Power
Switch on the electrical control enclosure to the "Off"
position.
Drain the wash tank per 2.4.3.
Tank does not need
to be drained to replace the rinse thermometer.
6-2
Advertisement
Table of Contents
