Rear Panel Connections
POWER
12V
--A MAX
INPUT
A A A
B B B
Figure 2.
Rear Panel Ports
Connecting Power
Power inlet — Connect the provided 12 VDC, 3 A power supply to the rear panel power supply socket.
A
CAUTION: The DC output cables must be kept separate from each other while the power supply is
plugged in. Remove power before wiring.
ATTENTION : Les câbles de sortie CC doivent être séparés les uns des autres tant que l'alimentation
est branchée. Coupez l'alimentation avant d'effectuer les raccordements.
ATTENTION:
•
Do not connect any external power supplies until you have read the
•
Veuillez lire les encadrés «
alimentation externe.
SECTION A–A
Figure 3.
1. Cut the DC output cord to the length needed.
2. Strip the jacket to expose 3/16 inch (5 mm) of the conductor wire (see figure 3).
3. Ensure the connections have the correct polarity as shown in the figure above. The wire with ridges is the
ground wire.
4. Slide the exposed ends of the wire into the captive screw connector and secure by tightening the screws.
5. Use the supplied tie wrap to strap the power cord to the extended tail of the connector.
1
2
OUTPUTS
C C C
A
Smooth
Ridges
3/16"
A
(5 mm) Max.
Power Connector Wiring
LAN
D D D
ATTENTION
on page 6 » ci‑dessous avant de brancher une
POWER
12V
--A MAX
Power inlet
A
HDMI input
B
HDMI outputs
C
LAN port
D
ATTENTION
on page 6.
DA2 HD 8K L • Installation
5