Table of Contents
Advertisement
Mode 5 - Pulse EE (PEE)
Pulsed output triggered by a digital input. The delay and pulse width
are set as a number of encoder pulses.
Parameter
Trigger input
Gate input
Pulse delay
|
30
Use
The channel can take any input, or the output of any other
channel as its trigger. This can be configured using the
CC320 web pages and selecting a trigger source using the
pull down menu. Alternatively the trigger input source
can be set using the i parameter of the 'Set the output'
command RSc,m,i,g,f (see Section 10.3, "Commands").
0 for the free-running timer, if IP0 is enabled
1 to 8 for IP1 to IP8
9 to 16 for OP1 to OP8 (channels CH1 toCH8)
17 to 24 for virtual outputs (channels CH9 to CH16).
The channel can take any input, or the output of any other
channel as it's gate. The gate enables/disables the output
of the channel. This can be selected using the CC320 web
pages and using the pull-down menu. Alternatively the
gate input source can be set using the g parameter of the
'Set the output' command RSc,m,i,g,f (see Section 10.3,
"Commands").
0 for None
1 to 8 for IP1 to IP8
9 to 16 for OP1 to OP8 (channels CH1 toCH8)
17 to 24 for virtual outputs (channels CH9 to CH16).
Specifies the number of encoder pulses from trigger to
pulse output using the web interface Pulse Delay field or
the p parameter of the Output Pulse Timing command
RTc,p,d (see Section 10.3, "Commands").
Advertisement
Table of Contents
