Table of Contents
Advertisement
On-board help
Measure route
Preparation
Before a measure is started, ensure:
The VIBXPERT 3 battery is fully charged and the device has sufficient storage capacity.
l
Required sensors and cables are laid out and in good condition; the RPM sensor requires
l
a support to do RPM measurements.
Device settings are set correctly.
l
Start route
Tap
the home screen Routes icon. All routes available in the device appear in the
route list.
Tap the route to be measured. The route summary screen is shown if the measure set-
l
ting Show route summary is switched on. This screen shows a summary of the inform-
ation related to the selected route.
If Show route summary is switched off, the route starts from where it stopped.
To measure route, do one of these:
l
Tap
measured. OR
Tap
Alternatively press either of the two yellow device ENTER buttons and go to the neces-
sary measure location.
80
to start to measure at the first location, which has initially not been
to resume to measure at the location last measured.
Version:1.0
Advertisement
Table of Contents
