Table of Contents
Advertisement
On-board help
If the user changes to the default measurement system, a hint to override any cus-
tomized settings is shown.
Channels & Sensors: used to show all the factory-configured and user defined
l
sensors; set default sensor for related channel; set up additional sensors .
Measurement:
l
Default measurement screen — the default format in which assets to be measured
are shown, is list.
Show route summary — when on (
route measurement is started. When off (
Detail route guidances — when on (
measurement will be applied and all steps must be confirmed. When off (
urement points are accessed directly.
Machine speed finder — when on (
tion measurements. The calculated RPM must be confirmed and possibly verified for
every measurement point. When off (
reference measurement point then transferred to all measurement points on the asset
via the stored kinematic model.
Note:Use Machine speed finder only when a reference speed point in relative
mode is available on the asset, and the asset comprises several machine trains
configured as a production line.
Practical tip:Turn Machine speed finder on for all measurement points on the
machine train, if the speed briefly fluctuates during asset measurement.
Sensor live values
Vibration location default — used to set the default parameter that is shown at a
20
), an overview of the route is shown when
), the overview is not shown.
), a step-by-step guidance to the route
), the asset RPM is calculated using the vibra-
), the asset RPM is determined at only the
), meas-
Version:1.0
Advertisement
Table of Contents
