Table of Contents
Advertisement
Note:It is possible to apply correction masses on both planes at the same time. It
is also possible to change the correction mode from free to fixed at any time in cor-
VIBXPERT 3
Shows the vibration overall values (velocity) in the initial
run with no trial masses on both planes A and B.
Shows the vibration overall values (velocity) for the trial
run with mass on plane A. The crossed out mass shows
that the mass was removed from the machine before the
next step.
Shows the vibration overall values (velocity) for the trial
run with mass on plane B. The crossed out mass shows
that the mass was removed from the machine before the
next step.
Shows the recommended correction mass and related
angle for both planes A and B. These values are entered
in
.
In this example, values for the selected balancing plane
A (
) are entered. Plane B values are entered when
the plane is selected (
– shows currently selected plane (A).
To change to plane B, tap
orange (
).
Shows current balancing step; in this case it is the fourth
step which is the first trim run (first correction).
Used to proceed to next step. Tap NEXT and follow hints
on the screen. Repeat measure procedure as described
above until the imbalance is reduced or removed.
)
. This changes color to
On-board help
119
Advertisement
Table of Contents
