Install Wind Vane; Install Rain Gauge Funnel; Install Batteries - Bresser 7003800 Instruction Manual

GB

3.1.1 Install wind vane

With reference to photo below, (Step 1) locate and align the flat are on the wind vane shaft to
the flat surface on the wind vane and push the vane onto the shaft. (Step 2) tighten the set
screw with a precision screwdriver.
Step 1 Step 2

3.1.2 Install rain gauge funnel

Install the rain gauge funnel and rotate clockwise to lock the funnel to the sensor array.
Step 2
Lock
Step 1
grooves

3.1.3 Install batteries

Unscrew the battery door at bottom of unit. Insert the 3 x AA batteries (non-rechargeable)
according to the +/- polarity indicated. The red LED indicator on the back of the sensor array
will turn on, and then begin flashing every 12 seconds.
Note
:
We recommend using non-rechargeable Lithium AA batteries for cold weather climate, but
normally Alkaline batteries are sufficient for use in most weather condition.
9