Site Selection; Getting Started; Wireless 7-In-1 Sensor - Bresser 7003800 Instruction Manual

2.2 Site selection

Before installing the sensor array, please consider the followings:
1. Batteries must be changed about every 2 to 2.5 years
2. Avoid radiant heat reflected from any adjacent buildings and structures. Ideally, the sensor
array should be installed at 1.5m (5') from any building, structure, ground or roof top.
3. Transmission range between sensor array and console could reach a distance of 150m
(or 450 feet) at line of sight, providing there are no interfering obstacles in between or
nearby such as trees, towers, or high voltage line. Check the reception signal quality to
ensure good reception.
4. Household appliance such as fridge, lighting, dimmers may pose Electro-magnetic
interference (EMI), while Radio Frequency Interference (RFI) from devices operating in
the same frequency range may cause signal intermittent. Choose a location at least 1-2
meter (3-5 feet) away from these interference sources to ensure best reception.
3.

Getting started

3.1 Wireless 7-in-1 sensor

1. Rain collector
2. Balance indicator
3. UVI / light sensor
4. Wind vane
5. Wind cups
6. Antenna
9
1
2
3
10
11
4
12
5
6
7
8 13
7. Solar panel
8. Radiation shield and
thermo-hygro sensor
9. Drain holes
10. Battery door
11. Red LED indicator
8
14
15
16
12. [ RESET ]
13. Mounting clamp
14. Adjustable hinge of solar
panel
15. Tipping bucket
16. Rain sensor