Direction Alignment; Pointing The Wireless 7-In-1 Sensor To South - Bresser 7003800 Instruction Manual

Note
:
- Any metal object can attract lightning strikes, including your sensor-array mounting pole. Never
install sensor-array in stormy days.
- If you want to install a sensor-array on a house or building, consult a licensed electrical engineer to
ensure proper grounding. Direct lightning impact on a metal pole can damage or destroy your home.
- Installing the sensor at high location may result in personal injury or death. Perform as many initial
inspections and operations as possible on the ground and in buildings or houses. Only install the
sensor-array on clear, dry days.
- Ensure the sensor-array installation place is stable and no vibration.

3.1.7 Direction alignment

Install the wireless 7-in-1 sensor in an open
location with no obstructions above and around the
sensor for accurate rain and wind measurement.
Locate the North (N) marker on top of the 7-in-1
sensor and align the marker to point North upon
final installation with a compass or GPS. Tighten
the mounting bracket around the diameter pole
using two screw and nuts provided.
Use the bubble level on the 7-in-1 sensor to make
sure the sensor is completely level for proper
measurement of rainfall.
North marker on top of the 7-in-1 sensor.
Use the bubble level on the 7-in-1 sensor to make
sure the sensor is completely level for proper
measurement of rainfall.

3.1.8 Pointing the wireless 7-in-1 sensor to south

The outdoor 7-in-1 sensor is calibrated to point to North for the maximum accuracy. However,
for the user's convenience (e.g. users in the Southern hemisphere), it is possible to use the
sensor with the wind vane pointing to South.
1. Install the 7-in-1 wireless sensor with its wind meter end pointing to South. (Please refer to
Section 3.1.7 for mounting details).
2. Select "S' in set hemisphere step (Please refer to Section 4.4 for setup details).
3. Follow the setup procedure to confirm and exit.
Note
:
Changing the hemisphere setting will automatically switch the direction of the moon phase on
the display.
Point to
NORTH
13
2 meter
off the
ground
mounting pole
not included
GB
Point to
SOUTH