Wireless Indoor Hygro-Thermo Sensor; Install Wireless Indoor Hygro-Thermo Sensor; Synchronizing Additional Sensor(S) (Optional) - Bresser 7003800 Instruction Manual

3.2 Wireless indoor thermo-hygro sensor
1. LCD display
2. Transmission status LED
3. Wall mounting holder
4. [ CHANNEL ] slide switch
3.2.1 Installing wireless indoor thermo-hygrosensor
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the sensor (e.g. Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and close the battery door
according to the polarity information marked on the battery compartment.
4. The sensor is in synchronization mode, and can be registered to the console within the next
few minutes. The flashing LED is showing the transmission status.
Note
:
- If you need to re-assign the sensor channel, slide the channel slide switch to the new channel
position. For the new channel number to be effective, press [ RESET ] on the sensor.
- Avoid placing this sensor in direct sunlight, rain or snow.

3.3 Synchronizing additional sensor(s) (optional)

The console can support 4 different air quality sensors, up to 3 wireless thermo-hygro sensors
and up to 3 water leak sensors. Please contact your local retailer for details of different sensors.
Some of these sensors are multi-channel. Before inserting the batteries, set the channel
number if channel slide switch is located at back of sensors (inside battery compartment). For
their operations please refer to the manuals that come with the products.
1
2
3
4
5
6
7
5. [ RESET ]
6. [ °C / °F ]
7. Battery compartment
14