10
Operating from the COP Controls
Figure 2 shows the car operating panel (COP).
Figure 2
To operate the lift from the COP controls:
1 Insert the key into the key switch and turn it to the ON position to activate
the operating buttons.
2 Apply constant pressure on the Up/Down button (as required) to move the
platform to the desired landing. Note that the lift will not move if the gate is
open.
3 When the lift reaches the landing, the gate will unlock automatically. If you
need to re-open the door after a delay, turn the key to the ON position and
press the call button again to unlock the gate.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
5 Pressing the Emergency Stop button during travel will stop the lift
immediately and activate the alarm. The Emergency Stop overrides the
landing station controls. Pull the Emergency Stop out to return the lift to
normal operation.
6 If the gate is locked at a landing for more than 10 seconds, you can press the
Up button to unlock the gate.
M2LIFT Owner's Manual
Key Switch
Up/Down
Emergency
Stop
Part No. 001103, 30-m01-2024