Operating From The Cop Controls - Savaria V1504 Owner's Manual

Operating from the COP Controls

Figure 2 shows a sample car operating panel (COP).
Figure 2
To operate the V1504 from the COP controls:
1 Insert the key into the switch (if equipped) and turn it to the ON position to
activate the operating buttons.
2 Press the appropriate landing button to move the lift to the destination.
Note that the V1504 will not move if one of the doors is open.
3 When the lift reaches the landing, the door will unlock automatically (for
units with mechanical GAL locks). For units with an interlock (WR500 or
Prolock), the door will unlock automatically for a few seconds when the lift
reaches the landing. If you need to re-open the door after the delay, turn the
key to the ON position and press the call button again to unlock the door.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
5 Pressing the Emergency Stop button during travel will stop the lift
immediately and activate the alarm. The Emergency Stop overrides the
landing station controls. Pull the Emergency Stop out to return the lift to
normal operation.
6 Pressing the Alarm button during travel will activate the alarm. If the door
is locked at a landing, you can press the Alarm button to unlock the
current landing door.
Part No. 000692, 02-m01-2024
Landing buttons
Key switch
Alarm
Emergency stop
V1504 Owner's Manual
9