5
TROUBLESHOOTING, CARE AND MAINTENANCE
5.1
General Instructions
⚠
WARNING
+
Do not make any improper changes to the equipment.
⚠
CAUTION
+
Damaged or worn components may aff ect your safety and the life of the equipment.
Safety can only be guaranteed if you check the equipment regularly for wear and damage.
Immediately replace damaged or worn components. In such a case, contact the contract
partner. The equipment must not be used until it has been repaired. If necessary, use only
original spare parts.
ATTENTION
+
In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2
Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually suffi cient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Cracking in the pedal
area
Equipment wobbles
Handlebar/saddle
wobbles
Display is blank/is not
working
No pulse display
Cause
Pedals loose
Equipment is not level
Loose screws
Batteries empty or loose
cable connection
+
Sources of interference in
the room
+
Unsuitable chest strap
+
Wrong position of chest
strap
+
Chest strap defective or
battery empty
+
Pulse display defective
Solution
Tighten the pedals
Align the feet
Tighten screws fi rmly
Replace batteries or check cable
connections
+
Eliminate sources of interference (e.g.
mobile phone, WLAN, lawn mower
and vacuum cleaner robot, etc. ...)
+
Use a suitable chest strap (see
RECOMMENDED ACCESSORIES).
+
Reposition
chest
moisten electrodes
+
Changing batteries
strap
and/or
31
Need help?
Do you have a question about the IC70 Smart and is the answer not in the manual?