Installation; General; Installing The Drawer Warmer - Hatco CDW-3N Series Installation And Operating Manual

INSTALLATION

General

The Convected Drawer Warmer is shipped with most
components pre-assembled. Casters or legs must be installed
on location. Care should be taken when unpacking the shipping
carton to avoid damage to unit and the components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 21°C (70°F).
FIRE HAZARD: Locate unit a minimum of 25 mm (1") from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
NOTE: The unit must be transported in the upright position.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
3. Make sure the desired installation location is appropriate.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 21°C
(70°F). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is located on solid, level flooring.
• Make sure the unit is at the proper height in an area
convenient for use.
4. Install the unit.

Installing the Drawer Warmer

Convected Drawer Warmers are freestanding units that require
the installation of legs or casters as well as anti-tip protection
before operation.
1. Remove the plastic bag containing the four legs or casters
from the drawer of the unit.
2. Remove any pans from the drawers of the unit.
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.
3. Carefully lay the unit on its left or right side (requires two
people).
4. Install each leg or caster. Refer to the appropriate
procedure in this section.
5. Return the unit to its upright position (requires two people).
For units on legs — If the unit is not level or rocks, turn the
adjustable tip/flange of the appropriate leg to level the unit.
6. Install the appropriate anti-tip protection. Refer to the
procedure in this section.
• Make sure the unit is level before fastening leg flanges
to the floor in the anti-tip protection procedure.
Installing Casters
1. Align the four holes on the caster plate with the four holes
in the bottom of the unit at one corner of the unit.
2 Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
3. Repeat steps 1 and 2 for the remaining three casters.
Caster Plate
Bolt
Caster Installation
Installing Legs
1. Thread a leg into the hole located at one corner of the unit.
2. Hand-tighten the leg until snug. Do not over-tighten.
3. Repeat steps 1 and 2 for the remaining three legs.
Installing Anti-Tip Protection
Freestanding units may require anti-tip protection by either
fastening the leg flanges to the floor or installing the Anti-Tip
Wall Bracket supplied with the unit (both available at time of
order from Hatco).
Fastening Leg Flanges to the Floor
1. Make sure the unit is in the desired
location and has been properly leveled.
2. Using the appropriate fasteners, secure
each leg flange to the floor.
Installing the Anti-Tip Wall Bracket
1. Move the unit to the desired location against the wall
where the wall bracket will be installed. Make sure the
unit has been properly leveled.
2. Loosen, but do not remove, the two screws that secure the
anti-tip plate to the top of the unit.
6
Mounting
Bracket
Shorten
Lengthen
Adjustable
Flange
Leg Installation
Leg Flange
CDWCEM-1123