Plug Configurations; Installation; Hdw & Hdw-N; Hdw-B & Hdw-Bn - Hatco HDW-1 Installation & Operating Manual

PLUG CONFIGURATIONS

Free-standing units are supplied from the factory with
an electrical cord and plug installed. Plugs are supplied
according to the applications as shown in Figure 5.
Built-in units are supplied with a flexible conduit and
applicable wiring.
! CAUTION
On free-standing units, plug unit into an electrical
outlet of the correct voltage, size and plug configura-
tion. If the plug and receptacle do not match, contact
a qualified electrician to determine the proper volt-
age and size and install the proper electrical outlet.
On built-in units, final connections should be made
by a qualified electrician.
-
HDW & HDW N MODELS
Care should be taken when unpacking shipping carton to
avoid damage to unit and components enclosed.
1. Remove the unit from the carton.
2. Remove plastic bag containing four adjustable legs
from inside the drawer.
!
CAUTION
Legs must be installed prior to operation of the unit.
3. Carefully lay unit on its side (requires 2 people).
Install legs to bottom of unit as shown in Figure 6.
Hand tighten legs until snug. Do not overtighten.
!
CAUTION
Do not lay unit on the front or back side or damage
to unit could occur.
4. Return unit to the upright position.
5. Remove all tape from the unit.
NOTE: Legs are adjustable for leveling the unit. Use a
9/16" (14 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
- -
HDW B & HDW BN MODELS
Care should be taken when unpacking shipping carton to
avoid damage to unit and components enclosed.
1. Remove the unit from the carton.
Printed March 1999
NEMA 5-15P
NEMA 6-15P
Figure 5. Plug Configuration
Leg Adjustment
Adjust leg using a 9/16"
(14 mm) open-end
wrench and turning bot-
tom of leg accordingly.
Figure 6. Adjustable Legs
! CAUTION
Do not lay unit on the front or back side or damage
to the unit could occur.
2. Read information under Location before determining
installation site.
3. Determine the cabinet size opening using the chart in
Figure 7.
NOTE: Maintain a minimum clearance of 1" (2.5 cm)
between the cutout opening and the floor.
4. After cabinet opening is prepared to the proper size,
5
SPECIFICATIONS
NEMA 5-20P
CEE 7/7 Schuko
BS-1363

INSTALLATION

Leg Installation
Form No. HDWM-0399