Installation; General - Hatco Flav-R-Savor FSHC-7W Series Installation And Operating Manual

English

General

Flav-R-Savor Portable Holding Cabinets are shipped with most
®
components installed and ready for operation. The following
installation instructions must be performed before plugging in
and operating the cabinet.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAZARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
Locate unit in an area that is convenient for use. The
location should be level to prevent unit or its contents
from falling accidentally and strong enough to support the
weight of the unit and contents.
1. Remove the unit from the carton.
2. Remove all loose items shipped inside the cabinet such as
the box containing the adjustable pan slides, the casters/
legs, etc...
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces
of the unit.
Front
Shelf Support
Slot
Adjustable Pan Slide
Reservoir Cover
Form No. FSHC7WM-0121
CAUTION
Angle pan slide
hook into slot and
rotate pan slide down.
Built-In Water Reservoir
Installing the Components (FSHC-7W1-EE shown)
NOTE: If 4" (102 mm) legs, 6" (152 mm) legs, or bumper
assembly installation is required, refer to the OPTIONS
AND ACCESSORIES section in this manual for
installation instructions.
4. Install the 4" (102 mm) casters onto the bottom of the cabinet.
A low profile caster option is available for the FSHC-5W
series—use the same procedure below to install.
Do not lay unit on side with control panel or damage to unit
could occur. Make sure all water is drained prior to laying
unit on its side.
a. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and the
floor to prevent marring the cabinet finish.
b Install the two swivel casters to the front of the unit using
four mounting screws (provided). Tighten securely.
c. Install the two stationary casters to the back of the unit
using four mounting screws (provided). Tighten securely.
d. Return the unit to its upright position. This step requires
two people.
5. Unpack the adjustable pan slides from the box and
install them inside the cabinet. There are ten or fourteen
adjustable pan slides—half on each side of the cabinet.
Four shelf supports, two on each side of the cabinet,
support the pan slides.
To install each pan slide:
a. Align the hooks at each end of the pan slide with the
desired slots on the front and rear shelf supports.
b. Angle the pan slide hooks into the slots and let the pan
slide rotate down into position.
Drain Hose and Valve
7

INSTALLATION

NOTICE
Drip Tray
4" SwivelCaster
Mounting Screw
Low Profile Caster (optional,
FSHC-5W1-EE only)