Table of Contents
Advertisement
Available languages
Available languages
General
DRAWERMAX
Drawer Warmers are shipped with most
®
components pre-assembled. Care should be taken when
unpacking the shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 21°C (70°F).
FIRE HAZARD: Locate the unit a minimum of 25 mm (1")
from combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could occur.
NOTICE
Do not lay unit on front or back side. Damage to unit could
occur.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
3. Make sure the desired installation location is appropriate.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 21°C
(70°F). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is located on solid, level flooring or
in sturdy cabinetry.
• Make sure the unit is at the proper height in an area
convenient for use.
4. Install the unit. Refer to the appropriate installation
procedure in this section.
Installing HDM-x and HDM-xN Models
HDM-x and HDM-xN models are freestanding units that require
the installation of legs or casters as well as anti-tip protection
before operation.
1. Remove the plastic bag containing the four legs or casters
from the drawer of the unit.
2. Carefully lay the unit on its side (requires two people).
3. Install each leg or caster. Refer to the appropriate
procedure in this section.
4. Return the unit to its upright position (requires two people).
For units on legs — If the unit is not level or rocks, turn the
adjustable tip/flange of the appropriate leg to level the unit.
5. Install the appropriate anti-tip protection. Refer to the
procedure in this section.
• Make sure the unit is level before fastening leg flanges
to the floor in the anti-tip protection procedure.
HDM_AAM-0623
Installing Legs
1. Thread a leg into the hole located at one corner of the unit.
2. Hand-tighten the leg until snug. Do not over-tighten.
3. Repeat steps 1 and 2 for the remaining three legs.
Leg Installation on HDW-2 Model
Installing Casters
1. Align the four holes on the caster plate with the four holes
in the bottom of the unit at one corner of the unit.
2. Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
3. Repeat steps 1 and 2 for the remaining three casters.
Caster Installation on HDW-3 Model
7
INSTALLATION
Shorten
Lengthen
Adjustable Tip
102 mm (4") Leg
76 mm
Caster
Bolt
Advertisement
Table of Contents
