Use The Adp5055 Gui Software - Analog Devices ADP5055-EVALZ User Manual

UG-1930
USE THE ADP5055
Figure 12 shows the optional ADP5055-EVALZ connection
diagram for using the ADP5055_GUI software to evaluate the
advanced functionalities through the PMBus serial interface.
Besides the power supply, the following items are also necessary
for using the ADP5055_GUI software:

A PC with the ADP5055_GUI software and the
CABLEZ dongle driver properly installed

A 1 m USB Standard A to Mini B cable (included in the
USB-SDP-CABLEZ package)

An USB-I2C-ADPTZ
10-pin Micro-MaTch connector to a 3-pin 0.1" I
which is also included in the USB-SDP-CABLEZ package
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
GUI SOFTWARE
USB-SDP-
adapter board that can convert the
2
C header,
POWER SUPPLY
V = 4.5V TO 18V
IN
USB-I2C-ADPTZ
ADAPTER
USB DONGLE
Figure 12. Optional ADP5055-EVALZ Connection Diagram
Figure 13. ADP5055 GUI Default Values
To run the ADP5055_GUI, go to Start > ADP5055_GUI >
ADP5055_GUI. If the program starts properly, and the
ADP5055-EVALZ is detected, the ADP5055 GUI appears as
shown in Figure 13.
Choose the proper ADP5055 device PMBus address. (Note that
the default address with 23.7 kΩ on the CFG2 pin resistor is
0x70). Click Read all Registers to view the default values of all
registers initialized in the GUI.
SYNC/MODE
VOUT3
J-EN1 J-EN2 J-EN3
Rev. 0 | Page 8 of 16
ADP5055-EVALZ User Guide
VOUT1
VOUT2