Option Cards - ETC EchoDIN Power Control Processor Mk2 Installation Manual

ETC Installation Guide
Power Control Processor Mk2

Option Cards

Each option card in the system includes a wire harness for connecting to the PCP-Mk2.
The EchoDIN 0–10V Option Card (E-DIN-LVD)
provides 24 outputs for control of 4-wire
current-sink, 0–10 VDC controlled drivers and
ballasts.
DALI Control Option
The EchoDIN DALI Control Option card
(E-DIN-DALI) controls 24 loops of 64 DALI
compatible fluorescent ballasts in broadcast
mode.
Install an Option Card
1. Determine the Primary/Secondary switch setting. See
page .
2. Install the option card in the enclosure. See
3. Connect wiring to the option card. See
• For a Contact Option Card, make sure to program the card. See
Input Card on page 14
To remove an option card from Din rail for service or inspection, see
DIN rail on page 14
Power Control Processor Mk2
0-10V Option
.
.
Page 8 of 15
Contact Input Option
The EchoDIN Contact Input Option Card
(E-DIN-CI) provides the ability to directly control
relays using a momentary or maintained dry
contact input.
Primary/Secondary Switch on the facing
Install the Option Card to DIN rail on page 10
Connect Wiring to an Option Card on page 10
Program the Contact
Remove an Option Card from
.
.
ETC