Electrical Specifications; Connect Control Wiring - ETC EchoDIN Power Control Processor Mk2 Installation Manual

ETC Installation Guide
Power Control Processor Mk2

Electrical Specifications

Note:
less.
Rated voltage (U )
n
Rated operational voltage (U
Rated insulation voltage (U
Rated impulse withstand voltage (U
Rated current of the assembly (I
Rated current of a circuit (I
Rated peak withstand current (I
Rated short-time withstand current (I
Rated conditional short circuit current of the assembly (I
Rated diversity factor (RDF)
Frequency
Pollution degree
Earthing system
Degree of protection
EMC classification
Construction

Connect Control Wiring

Note:
less.
Purpose
DMX In and DMX Thru
Ethernet
Emergency In and Out
Contact Input Option
Card
0-10V Dimming Control
Option Card
DALI Option Card
Power Control Processor Mk2
Short circuit protection is required. EN curve "C" circuit breaker rated 16 A or
Electrical Specifications
)
e
)
i
)
imp
)
nA
)
nc
)
pk
)
cw
Short circuit protection is required. EN curve "C" circuit breaker rated 16 A or
Data and Control Wire Specifications
Recommended Cable
Belden 9729
Belden 1583A (Category
5e or better)
2
2–1.5 mm (16 AWG),
twisted pair
2
4–0.5 mm (12–18 AWG)
wire
2
4–0.25 mm (12–
24 AWG) wire
2
4–0.25 mm (12–
24 AWG) wire
230 VAC L-N, 400 VAC L-L
230/400 VAC
500 VAC
2.5 kV
4 x 15 A (4x15 A relay module)
2 x 2.6 A (Dimmer module)
15 A (relay module)
2.6 A (dimmer module)
6 kA
6 kA
) 6 kA
cc
0.8
50/60 Hz
2
TN-S, TN-C, TN-C-S
IP10
Environment "B"
Open-type assembly
Notes
Contact ETC for list of equivalents. DMX is RS485 serial and can be installed
in series (i.e. daisy-chain) topology.
Install per EIA/TIA 568B. Test to TSB 67 standards.
Contact input for UL 924 emergency lighting loads
Maximum of 24 individual dry contact inputs.
Maximum of 50 ballasts (100 mA) per channel
Maximum of 64 ballasts per loop
Page 4 of 15 ETC