ETC EchoDIN Power Control Processor Mk2 Installation Manual page 5

ETC Installation Guide
Power Control Processor Mk2
B
Install the Power Supply
The wire harness with red and black wires
(included) connects the PCP-Mk2 to the power supply.
One end of the harness has a connector and the other
has bare wires. The wires are pre-stripped to the correct
length for termination.
1. Pull gently to remove the clear cover on the face of
the power supply.
2. Using a small Philips screwdriver, loosen the screw
terminals.
3. Insert the black wire into the terminal labeled "-".
Tighten the screw to secure the wire.
4. Insert the red wire into the terminal labeled "+". Tighten the screw to secure the wire.
5. Insert the earth/ground wire into the terminal labeled
wire.
6. Insert neutral wire (typically blue) into the terminal labeled "N". Tighten the screw to secure
the wire.
7. Insert the Line wire (typically brown) into the terminal labeled "L". Tighten the screw to
secure the wire.
8. Loosen the screw terminals on the dedicated breaker.
9. Insert the loose end of the neutral wire into the terminal labeled "N". Tighten the screw to
secure the wire.
10. Insert the loose end of the line wire into the terminal labeled "L". Tighten the screw to
secure the wire.
Power Control Processor Mk2
PCP-Mk2 Connections (bottom edge)
A
L
C D E
A User Interface
B Relay module control connection H S2 switch
C Emergency Out
D Emergency In
E DMX In
F DMX Thru
F G H I J
G S1 switch
I Primary/Secondary switch
J Option 2
K Option 1
L Ethernet
Page 5 of 15
K
A Earth/Ground
B Neutral: to breaker
C Line: to breaker
. Tighten the screw to secure the
A
B
C
ETC