ETC EchoDIN Power Control Processor Mk2 Installation Manual page 3

ETC Installation Guide
Power Control Processor Mk2
System Component
A EchoDIN breakers: one for the PCP-
Mk2 and one for each relay and
dimmer are required
B EchoDIN relay modules: three modules
shown for a total of 12 relays
C EchoDIN PCP-Mk2 (User Interface)
D 24 VDC power supply
E Option cards: Contact Input Option
(shown), 0-10V Option Card (shown),
DALI option card (not shown).
F Wiring to the power source
G Wiring to the load
Not RideThru Option
shown
Not 2x600 W Dimmer
shown
Not Relay and dimmer control cables
shown
Not Accessory control cables
shown
Power Control Processor Mk2
ETC Model Number
4x16 A Relay E-DIN-4RELAY
2x32 A Relay
PCP-DIN-Mk2
PS435
E-DIN-CI, E-DIN-LVD, E-DIN-DALI
ERP-RTO
E-DIN-2DIM
EchoDIN-CC
EchoDIN-OC
Page 3 of 15
Wire Specification Notes
One ribbon cable (not For use with
included) is required 230 V systems
between the controller only.
and the first power block.
DIN rail
mounted
power supply
only
Harness included with kit See
Cards on
page 8
One ribbon cable (not
included) is required
between the controller
and the first power block.
28 cm (11 in) Custom
lengths up to
20 m can be
built upon
request
61 cm (2 ft) Custom
lengths up to
20 m can be
built upon
request
Option
ETC