Table of Contents
Advertisement
Step 3: Then the four given screws are screwed into the anchors to finish
the wall-mount installation, as shown below.
3.2 Wall Hanging Installation
To hang the Wall-mount Managed Switch on the wall, simply follow the
following steps:
Step 1: Drill 2 holes (one hole on each side) with 8mm diameter on the wall;
the distance between the 2 holes is 230 mm and the line through
them must be horizontal.
Step 2: Place two anchors inside the hole by hammering them. Then screw
the two screws leaving a space of 2mm apart as shown in the circled
diagram below.
6
2 3 0 m m
1 2 4 m m
Advertisement
Table of Contents
