Suzuki LT-R450K6 Instruction Manual page 154

4-24 FI SYSTEM
DIAGNOSIS
USE OF SDS DIAGNOSTIC PROCEDURES
Do not disconnect couplers from ECM, the battery cable from
the battery, ECM ground wire harness from the engine or main
fuse before confirming the malfunction code (self-diagnostic
trouble code) stored in memory. Such disconnection will erase
the memorized information in ECM memory.
'
Malfunction code stored in ECM memory can be checked by
the SDS.
'
Be sure to read "PRECAUTIONS IN SERVICING" 0 4 - 3 )
before inspection and observe what is wrilten there.
Set up the SDS tool. (Refer to the SDS operation manual for
'
4
further details.)
Read the DTC (Diagnostic Trouble Code) and show data
when trouble (displaying data at the time of DTC) according to
~14
instructions displayed on SDS.
Not only is SDS used for detecting Diagnostic Trouble Codes
. , ,
but also for reproducing and checking on screen the failure
condition as described by customers using the trigger.
:
-1
* How to use trigger. (Refer to the SDS operation manual for
further details.)
e
09904-41010:
SDS set to01
99565-01010-007: CD-ROM
Ver.
7