Suzuki LT-R450K6 Instruction Manual page 139

FI SYSTEM DIAGNOSIS 4-9
USING THE MULTI-CIRCUIT TESTER
Use the Suzuki multi-circuit tester set (09900-25008)
Use well-charged batteries in the tester.
Be sure to set the tester to the correct testing range.
USING THE TESTER
Incorrectly connecting the
[ii
and
i,?)
probes may cause the
inside of the tester to burnout.
If the voltage and current are not known, make measure-
ments using the highest range.
When measuring the resistance with the multi-circuit tester
i i
I ,
-
will be shown as 10.00 MQ and
"1"
flashes in the display.
Check that no voltage is applied before making the measure-
&,
t i , . &
. : ;
ment. If voltage is applied the tester may be damaged.
After using the tester, turn the power off.
@
09900-25008: Multi-circuit tester set
NOTE:
" When connecting the multi-circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
' Use the needle pointed probe to prevent the rubber of the
water proof coupler from damage.
@
09900-25009: Needle pointed probe set