Table of Contents
Advertisement
2. Remove the current label sheet that is held between cover and device.
3. Place a new label sheet onto the cover.
4. Put the cover back into its place, aligning the centered metal plate first. It snaps into place
magnetically.
It is possible to prepare your own paper cutouts in case you frequently need to label the
fields. A PDF template is available upon request from your support. When choosing the
paper type, ensure that its thickness allows sufficient light to pass through.
3.9. Control Section
The M-32 AD Pro II-D can be configured at the device.
To do so, the TFT display shows a menu. The adjacent encoder knob is used to navigate and change
settings.
The encoder can be pushed in order to activate an item,
and rotated left and right in order to select an item.
If the device is powered on but the display shows no content, dark mode may be active.
Rotate the encoder to temporarily bypass this mode and show the display.
3.10. Power Supplies
The M-32 AD Pro II-D has two internal power supplies (PSUs) that are connected via IEC C14 inlets
labeled "PSU 1" and "PSU 2" at the rear of the device. The power supplies are designed with a wide-input
voltage range, accommodating a variety of power sources. They are short-circuit-proof, have an
integrated line-filter, are fully regulated against voltage fluctuations, and suppress mains interference.
RME M-32 AD Pro II-D User's Guide
3.9. Control Section | 9
Advertisement
Table of Contents
