Function Control; General; Electric; Suction Plates - probst JM-VARIO-200-B Operating Instructions Manual

Safety
2.8

Function Control

2.8.1 General

•
Before every usage of the device check the functions and the working condition.
•
Maintenance and lubrication are only permitted when device is shut down!
•
Do not use the device, until all faults which can cause safety hazards are removed.
•
If there are any cracks, splits or damaged parts on any parts of the device, immediately stop using
it.
•
The operating instructions must be available at the workplace every time.
•
Do not remove the type plate of the machine.
•
Unrecognisable information signs (such as regulatory or prohibition signs) must be replaced.

2.8.2 Electric

•
Check all electric cables for connection before each use.
•
Defective electrical parts may be exchanged only by qualified personnel in the dead condition.
•
The electric cables must be free of breaks and abrasion. Take care that there are no outstanding
edges, where the hoses could get stuck.
2.9

Suction plates

2.9.1 Avoiding damage

•
To avoid damage (cracks, material abrasion) to the rubber seal on the suction plate, the following
must be noted:
•
During operation of the device, it must generally be ensured that the suction plate does not touch or
bump against other products or other objects when lifting, setting down or transporting products.
•
Otherwise, the rubber seal may be damaged by the suction plate (risk of loss of suction power). The
product (stone slab) could fall down. Danger of accident!
52000029 / 52000029-150 / 52000029-200 11 / 37 GB