Setting The Floating State With Load - probst JM-VARIO-200-B Operating Instructions Manual

Operation
6.1.2

Setting the floating state with load

Adjust the adjusting screw (2) to set the hovering state with load
(caution, not to be confused with the floating state without load).

Rotate clockwise → Floating state decreases

Turning counterclockwise → Hovering state increases
The control lever (1) must not be left in the "Lift" position for more than 90 seconds,
otherwise
the fan may be damaged and fail, the warranty will be invalidated and energy will be
wasted unnecessarily.
The suspended state with load should not be in the highest lifting hose position, as otherwise
the fan may be damaged and fail, invalidating the warranty and wasting energy unnecessarily.

Slowly move the control lever (1) downwards - "Lower". The
vacuum lifting hose relaxes and the suction pad lowers with the
load.

Do not press the control lever down abruptly as far as it will go while
holding the operating handle (3). Otherwise the load may drop
suddenly as the vacuum is completely released.

Lower the load at the desired location.

To set down the load, press the control lever fully down, tilt the
valve box slightly and lift.
Further details can be found in the enclosed operating
instructions for the control unit
Ill. 15
52000029 / 52000029-150 / 52000029-200
Ill. 16
25 / 37
Ill. 17
GB