Table of Contents
Advertisement
A
NEUVIDEO
FRONT PANEL
LCD SCREEN:
Display matrix switching status, input / output port, EDID, Baud rate, IP Address, etc.
q
PWR INDICATOR:
The LED is on green when the device is working. The LED is on red when the device is on standby.
w
IR:
IR signal receiver. Receiving the signal from the IR remote.
e
INPUT / OUTPUT BUTTONS:
r
for the output port.
MODE (MATRIX / MULTIVIEWER / VIDEO WALL):
t
MATRIX: In matrix mode, you can press an output button (1~4) firstly and then press an input button (1~4) to select the corresponding
input source for the output port.
MULTIVIEWER: In multiviewer mode, the Output buttons are used as Windows. You can press a window button (1~4) firstly and then
press an input button (1~4) to select the corresponding input source for the window.
VIDEO WALL: In video wall mode, the Output buttons are used as Groups. you can press a group button (1~4) firstly and then press an
input button (1~4) to select the corresponding input source for the group.
MENU / ENTER / UP /DOWN:
y
1. On the initial LCD display screen, press "MENU" button. There are OUTPUT/MV/VM/INPUT/EXTAUDIO/SET items to be selected.
2. Press the "UP/DOWN" button to select "SET" item.
3. Press the "ENTER" button to enter into the next level menu. There are LCD ONTIME/BAUD RATE/IP INFO/BG PATTERN/REBOOT/
RESET items to be selected.
4. Press the "UP/DOWN" button to select "RESET" item.
5. Press the "ENTER" button to confirm the selection.
6. Press the "ENTER" button, and then it will prompt: SUCCESS!
Note:
• Pressing the "MENU" button will return to the previous menu.
• In any level menu, it will reture to the initial display screen if no operation goes on within 10 seconds.
POWER BUTTON:
Press the button for 1 second to enter the standby mode, then quickly press it to wake up the device.
u
LOCK BUTTON:
Short press the button to lock front panel buttons (Except the power button); press it again to unlock.
i
Press an output button (1~4), then press an input button (1~4) to select the corresponding input source
Press the buttons to select the video mode as required.
Take RESET, for example.
OPERATION CONTROLS & FUNCTIONS
3
Advertisement
Table of Contents
