SAFETY INFORMATION To ensure the best results from this product, please read this manual and all other documentation before operating your equipment. Retain all documentation for future reference. Follow all instructions printed on unit chassis for proper operation. To reduce the risk of fire, do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. Make sure power outlets conform to the power requirements listed on the back of the unit.
• Use only the supplied power supply unit (PSU). Do not use the PSU if it is damaged. The ANI-QUAD-MINI HDMI Quad Screen Multiviewer allows you to simultaneously display real-time HDMI/DVI video from (4) • Do not allow anything to rest on the power cabling or allow any weight to be placed upon it or any person walk on it.
FEATURES FEATURES • Compliant with HDMI 1.3a, HDCP 1.2 • Supports multiplexed HDMI (4) inputs and (1) output • Support 4x1 Quad Multi-viewer and seamless switch • Support scaler up, scaler down function • Support digital audio format LPCM/AC3/DTS • Support button, IR, RS-232 etc. various controlled ways •...
OPERATION AND FUNCTIONS FRONT PANEL ON/OFF: Power on/off switch. SERVICE: For factory use only. IR : Remote control receiver window. POWER LED: This red LED illuminates when the device is connected to the power supply. IN1, 2, 3, 4 LED: These red LED illuminates when the output has selected the corresponding input.
Page 7
OPERATION AND FUNCTIONS CAT RECEIVER DC 5V: Connect from 5V DC power supply into the unit and connect the adaptor to an AC outlet. IR RX: Connect to the IR Receiver for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR receiver. IR TX: Connect the IR Blaster cable included in the package for IR signal transmission.
CONNECT AND OPERATE WIDEBAND IR (30KHz---60KHz) INTRODUCTION IR BLASTER (TX): To control the source: Plug IR Blaster into IR TX port of transmitter unit. Place blaster in front of the IR eye of the source. IR RECEIVER (RX): To control the source: Plug IR Receiver into IR RX port of receiver unit. Place receiver at or near display. DETAIL DESCRIPTION OF DISPLAY MODES The quad multi-viewer has (3) display modes.
These buttons can adjust the display picture contrast, brightness, color and sharpness. PC GUI INTERFACE www.a-neuvideo.com/shop/ANI-QUAD-MINI.html INSTALLATION: Download the GUI software from our site Just use a cable to connect the PC via RS-232 port and copy “Quad multi-viewer.exe” to your PC to complete installation.
RS-232 SERIAL INTERFACE RS-232 SERIAL INTERFACE FOR CONNECTION TO A PC OR 3RD PARTY CONTROLER 1. Transmission rate: 115200bps 2. Data format: 8 data bits, No parity, 1 start bit and 1 stop bit 3. Flowing control: None Also know as 115200,8,n,1 RS-232 Configuration RS-232 cable is a straight thru cable and not null-modem Definition...
Page 12
COMMANDS Command Auction ANI-QUAD-MIN returns Options Resolution1. Change resolution to 1080P Resolution : 1080P/60 Resolution2. Change resolution to 720P Resolution : 720P/60 Resolution3. Change resolution to 1080I Resolution : 1080I/60 Resolution4. Change resolution to 1360x768 Resolution : 1360x768/60 Resolution5. Change resolution to 1024x768 Resolution : 1024x768/60 IN1.
Page 13
TERMS AND CONDITIONS OF USE PLEASE READ THE FOLLOWING TERMS AND CONDITIONS CAREFULLY BEFORE USING THIS HARDWARE, COMPONENTS AND SOFTWARE PROVIDED BY, THROUGH OR UNDER A-NeuVideo, INC (COLLECTIVELY, THE “PRODUCT”). By using installing or using the Product, you unconditionally signify your agreement to these Terms and Conditions.