Table of Contents
Advertisement
A
NEUVIDEO
Rear Panel
TCP/IP:
TCP/IP control port, connected to PC or router with a CAT cable.
q
RS-232 PORT:
Connect to a PC or control system by D-Sub 9-pin cable to transmit RS-232 command.
w
AUDIO INPUT (1~4):
L/R analog audio input port, connected to an analog audio input source such as DVD or Blu-ray Player. It follows
e
HDMI input (1~4), and the embeded audio can not be extracted to audio out channel to output.
AUDIO OUT (1~4):
r
OPTICAL: Optical audio output port, connected to an audio output device such as audio amplifier.
L/R AUDIO: Analog audio output port, supporting balanced/unbalanced audio output, with a maximum support of 2Vrms.
Balanced connection method: L+, L -,
Unbalanced connection method: L+,
IR INPUT (1~4):
Connect to IR receiver cable.
t
IR OUTPUT (1~4):
Connect to IR blaster cable.
y
IR EXT:
If the IR receiver window of the unit is blocked or the unit is installed in a closed area out of infrared line of sight, the IR receiver
u
cable can be connected to the "IR EXT" port to receive the IR remote signal.
HDMI INPUT PORTS (1~4):
i
HDMI cable.
HDMI OUTPUT PORTS (1~4):
o
LOCK:
Press to lock all button functions on the front panel. Press and hold for 3 seconds to release the lock function. The LCD will
a
display "LOCK" when the function is active.
DC 12V:
Connect to 24V/2.5A power adapter.
s
GND:
Connect the housing to the ground.
d
Note:
1. You can restore the factory settings via the front panel, web GUI or RS-232 command.
2. Power cut memory function is available except for standby status and panel lock.
3. The RS-232 and Web will be available in a few minutes when the device is powered on.
, R+, R
, R+
HDMI input ports, connected to HDMI source devices such as computer, DVD or set-top box with an
HDMI output ports, connected to HDMI display devices such as TV or monitor with an HDMI cable.
OPERATION CONTROLS & FUNCTIONS
4
Advertisement
Table of Contents
