Table of Contents
Advertisement
FRONT PANEL
ON/OFF:
Power on/off switch.
q
SERVICE:
For factory use only.
w
IR :
Remote control receiver window.
e
POWER LED:
This red LED illuminates when the device is connected to the power supply.
r
IN1, 2, 3, 4 LED:
These red LED illuminates when the output has selected the corresponding input.
t
INPUT BUTTON:
Press this button to select the Input source.
y
MODE BUTTON:
Press this button to cycle thru the different view display modes.
u
RESO BUTTON:
Press this button to cycle thru the HDMI output resolutions.
i
BACK PANEL
INPUT:
This slot is where you connect the HDMI source output from DVD, PS3, Set-top Box and Note Book.
q
OUTPUT:
The HDMI is where you connect the HDTV or monitor with HDMI cable for input source display.The UTP port connect to CAT
w
Receiver by CAT5e/6 cable for signal extend.The Coax is where you connect to the amplifier with coaxial cable.
IR RX:
Connect to the IR Receiver for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR receiver.
e
IR TX:
Connect the IR Blaster cable included in the package for IR signal transmission. Pace the IR blaster in direct line-of-sight of the
r
equipment to be controlled.
RS-232:
Connect the RS-232 port to the PC or notebook by RS-232 Cable.
t
DC 12V:
Plug the 12V DC power supply into the unit and connect the adaptor to AC wall outlet.
y
OPERATION AND FUNCTIONS
4
Advertisement
Table of Contents
