Introduction – Basic operations
This section describes the basic control ways to operate the camcorder.
How to turn on the power and select the mode
To supply the power for the camcorder, see "Step 1 Preparing the power supply" on
page 18.
(1) Slide the POWER switch down while pressing the small green button, then
(2) Slide the POWER switch down. Each time you slide it down, the mode
6
release your finger.
The camcorder is turned on, and then the camcorder turns to the CAMERA
mode so that the CAMERA lamp lights up.
changes as follows and its mode lamp also lights up.
CAMERA To use this mode when you record on a tape.
MEMORY/NETWORK (DCR-IP7/IP7BT only)
MEMORY: To use this mode when you record on a "Memory Stick," or
play back or edit the image in the "Memory Stick."
NETWORK: To use this mode when you use the network function. For
details, refer to the supplied network function operating
instructions.
VCR To use this mode when you play back or edit an image recorded on a tape
or "Memory Stick" ("Memory Stick" is only for the DCR-IP7/IP7BT).
1,2
POWER
CAMERA
MEMORY/
(CHG)
NETWORK
OFF
VCR
ON
MODE