Table of Contents
Advertisement
Recording a picture
Note
Do not touch the built-in microphone during recording.
To enable smooth transition
Transition between the last scene you recorded and the next scene is smooth as long as
you do not eject the cassette even if you turn off your camcorder.
However, check the following:
– When you change the battery pack, set the POWER switch to OFF (CHG).
If you leave your camcorder in standby mode for 5 minutes while the cassette is
inserted
Your camcorder automatically turns off. This is to save battery power and to prevent
battery and tape wear. To resume the standby mode, set the POWER switch to OFF
(CHG), and to CAMERA again. However, your camcorder does not turn off
automatically while the cassette is not inserted.
Recording data
The recording data (date/time or various settings when recorded) are not displayed
during recording. However, they are recorded automatically onto the tape. To display
the recording data, press DATA CODE on the Remote Commander during playback.
You can also use DATA CODE on the PAGE3 screen for this operation. (p. 36).
The battery usable time when you record using the LCD screen
The battery time is slightly shorter than the shooting time using the viewfinder.
If you press START/STOP twice in very short time interval
The operation may not work.
Adjusting the angle of the LCD screen
The LCD panel can be rotated as illustrated below.
180°
90°
OPEN
When you try to close the LCD panel, set it horizontally, then swing it into the
camcorder body.
29
Advertisement
Table of Contents
