Introduction - Basic Operations - Sony DCR-IP5E/IP7E Operating Instructions Manual

Introduction – Basic
operations
This section describes the basic operations used
to control and ways to operate the camcorder.
How to turn on the power and
select the mode
To supply power for the camcorder, see "Step 1
Preparing the power supply" on page 25.
(1) Slide the POWER switch down while pressing
the small green button, then release your
finger.
The camcorder is turned on, and then the
camcorder turns to the CAMERA mode so
that the CAMERA lamp lights up.
(2) Slide the POWER switch down. Each time you
slide it down, the mode changes as follows
and corresponding mode lamp also lights up.
CAMERA Use this mode when you record on
a tape.
MEMORY/NETWORK (DCR-IP7E only)
MEMORY: Use this mode when you record
NETWORK: Use this mode when you use
VCR Use this mode when you play back or
edit an image recorded on a tape or
"Memory Stick" (A "Memory Stick" can
only be used with the DCR-IP7E).
8
on a "Memory Stick", or play
back or edit a image in a
"Memory Stick".
the network function. For
details, refer to the supplied
network function operating
instructions.
1,2
POWER
CAMERA
MEMORY/ (CHG)
NETWORK
OFF
VCR
ON
MODE
(1)
(2)