Table of Contents
Advertisement
— Editing —
Dubbing a tape
– Using the A/V connecting cable
You can dub or edit on the VCR connected to your camcorder using your camcorder as
a player. Connect your camcorder to the VCR using the A/V connecting cable supplied
with your camcorder. The supplied A/V connecting cable is equipped with the S video
plug and the video plug. Use either the S video plug or the video plug depending on
the recorder. Do not connect both of the plugs to the recorder.
Before operation
•Set DISPLAY to LCD in the menu settings. (The default setting is LCD.)
•Press the following buttons to turn off the indicators so that they will not be
superimposed on the edited tape:
On your camcorder:
On the Remote Commander:
•Set DATA CODE on the PAGE3 screen to OFF.
(1) Insert a blank tape (or the tape you want to record over) into the VCR, and
insert the recorded tape into your camcorder.
(2) Prepare the VCR for recording: connect the A/V connecting cable, then set the
input selector to LINE.
Refer to the operating instructions of the VCR.
(3) Set the POWER switch to VCR.
(4) Play back the recorded tape on your camcorder.
(5) Start recording on the VCR.
Refer to the operating instructions of your VCR.
A/V
: Signal flow
When you have finished dubbing a tape
Stop the recording on the VCR, and stop the playback on the camcorder.
DISPLAY
DISPLAY, DATA CODE, SEARCH MODE
S VIDEO or VIDEO
AUDIO
IN
S VIDEO
VIDEO
AUDIO
81
Advertisement
Table of Contents
