Built-In Printer (Option); Replacing The Print Paper; Replacing The Ribbon Cartridge - Miele PG 8527 Operating Instructions Manual

Maintenance of the washer-disinfector

Built-in printer (Option)

Replacing the print paper

When the red indicator light behind the
front panel on the printer comes on,
replace the paper roll. Check the print
paper regularly.
To do this:
^ Open the front panel of the printer by
the upper edge, and pull down.
^ Remove the empty paper roll and
spindle together from the holder, fit
the new roll onto the spindle, and
install them back into the printer.
^ Guide the paper up and over the
paper transport roller (slit behind the
ribbon cartridge). Press the grey
paper transport button until the paper
re-emerges above the ribbon
cartridge.
^ Guide the paper through the slit in
the front panel. Shut the panel.
Replacement paper rolls (58 mm wide /
outer diameter approx. 50 mm) can be
obtained from Miele Service.
68

Replacing the ribbon cartridge

^ Open the front panel of the printer by
the upper edge, and pull down.
^ The ribbon cartridge is above the
paper roll. Pull it forward and out of
the holder and replace it with a new
one. The paper must be guided
between the ribbon and the cartridge
housing.
^ On the right, turn the small wheel for
manual ribbon transport clockwise
until the ribbon is taut.
^ Guide the paper through the slit in
the front panel. Shut the panel.
Replacement ribbon cartridges can be
obtained from Miele Service.