Akai MPC X User Manual page 367

Chorus 4-Voice
This effect is the same as Chorus 2-Voice, but adds
additional voices for more pronounced modulation.
Flanger Sync
This effect is the same as Flanger, but syncs to your project
tempo.
Flanger
A flanger is a modulated delay to emulate the sound created
when running two analog tape machines in parallel with a
slight time misalignment. Slow Rate settings can produce a
"whooshing" jet engine sound, while faster rates result in
more of a "warble."
Phaser 1
This effect applies multiple ganged all-pass filters to create
"notches," or sharp spikes, in the frequency spectrum. The
frequencies of these all-pass filters are usually modulated
by an LFO to create a sweeping sound.
Phaser 2
This effect is a variation on Phaser 1.
Phaser Sync
This effect is similar to Phaser 1/Phaser 2, but the LFO is
synced to the project tempo..
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Delay 0–100
Amount 0–100
Width 0–100
Feedback 0–100
Rate 0–100
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Rate 8 bars – 1/16 triplets 1/4
Feedback -100 – 100
Delay 0–100
Width 0–100
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Rate 0–100
Feedback -100 – 100
Delay 0–100
Width 0–100
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Rate 0–100
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Rate 0–100
Parameter Value Range
Dry/Wet 0–100 (dry–wet)
Rate 1 bar – 1/16 triplets
Default Value
100
20
80
80
50
10
Default Value
100
0
20
80
Default Value
100
10
0
20
80
Default Value
100
10
Default Value
100
10
Default Value
100
1/4
367