Machine Set Up Guide - Numatic NX 1K Original Instructions Manual

!
PLEASE READ
BEFORE
COMMENCING
ANY OPERATION AFTER
THE REMOVAL OF ALL
THE PACKAGING,
CAREFULLY
OPEN AND CHECK
THE CONTENTS.
TBL CONTENTS
● Isolator Key
● 1 x 30 Amp Fuse (Brush)
● 1 x 20 Amp Fuse (Vac)
● 1 x 2.5 Amp Fuse ● Maxi Fuse-puller
Open the fuse cover and fit vacuum and
brush fuses (contained in start-up pack)
into the fuse holders as illustrated.
(Fig. 1, 2, 3.)
Charge the machine to activate the
batteries (4).
Lift top tank assembly to reveal battery
compartment, ensuring you use the
handle grip provided.
After the batteries are activated, LEDs
should illuminate on the top of the
battery/batteries.
Numatic International Ltd recommends ONLY using 911948 NX1K LFP battery type Lithium Batteries provided with this machine.
!
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
Insert Isolator Key into ignition located on
the rear of the machine and switch the
machine on. (Fig. A)
Note: During vehicular transportation ensure the product is secured to avoid unnecessary movement.
Machine Set-up Guide
!
1
3
30Amp
20Amp
Use handle grips when
removing the
top waste-tank.
WHILE THE BATTERIES ARE EXPOSED.
A
Select forward and slow speed
then depress control triggers
(1) with both hands and press
the start switches (2) and
slowly drive machine off of the
pallet. (Fig.B)
When the machine is removed
and in a safe position, turn key
back to the position (0) 'OFF'
2
4
B
2
1
5
!
TBL4055T only
2
1