Raise / Lower Brush Deck; Fitting The Brush/Pad - Numatic NX 1K Original Instructions Manual

Machine Set-up Guide
! !
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Raising/Lowering the Brush Deck
To tip the deck into the down position (Operating mode). Press in the brush deck locking pin (Fig. A)
and rotate the brush deck (Fig. B & C). To change to brush deck up position, (Transit mode) simply lift the deck and the
spring loaded locking pin will activate to hold the deck up.
A B
C

Fitting the Brush/Pad

Turn on Water
TBL4045 450mm Brush or 400mm Pad.
TBL4055 / TBL4055T 550mm Brush or 508mm Pad.
Featuring the Nuloc brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Slide the brush / pad under the brush deck.
Fit the brush / pad onto the Nuloc drive chuck, twist to lock the brush / pad in place.
Safety gloves are recommended for the changing of used brushes.
Turn on the clean water tap.
+
-
6