Corded Buttonhole - ELNA eXcellence 580+ Instruction Manual

q
e
z
q
x
c

Corded Buttonhole

w
Machine settings
q Pattern:
w Thread tension:
e Presser foot:
r Foot pressure:
r
z Use the same procedure as the square buttonhole
w
x Lower the buttonhole lever.
c Pull the loose ends of the filler cord to tighten it.
49
MODE 1: 24
AUTO
Automatic buttonhole foot R
5
procedure. Set the stitch width to match the thickness
of the cord used. With the buttonhole foot raised,
hook the filler cord on the spur q at the back of the
buttonhole foot.
Bring the ends toward you under the buttonhole foot,
clearing the front end. Hook the filler cord into the
forks w on the front of the automatic buttonhole foot
to hold them tight.
Lower the needle into the garment where the
buttonhole will start, and lower the foot.
q Spur
w Forks
Pull the needle thread lightly to the left.
Start the machine and sew the buttonhole. Each side
of the buttonhole and the bartacks will be sewn over
the cord.
Remove the fabric from the machine, and cut the
sewing threads only.
Thread the each end of the cord through a hand-
sewing needle. Then draw the both ends to the wrong
side of the fabric and knot.
NOTE:
Cut the filler cord at both ends, if the filler cord is
stitched on the fabric and cannot be pulled.