2-8.4 Jp2: K/B Or Power Button Select; 2-8.5 Jp3: Lan Controller Select (For 75Frv-L Only) - SOLTEK 75FRV Manual

75FRV / 75FRV-L

2-8.4 JP2: K/B or Power Button Select

JP2 is designed on board to select key-
board , Mouse or the Power button as
the power-on control. Setting JP2 1-2
closed allows users to power up system
by keyboard/Mouse, while setting 2-3
closed will allow users to power up the
system by Power button. Yet users still
need to choose the KB/Mouse Power-on
mode in BIOS.(See "Integrated Periph-
erals" in BIOS Setup.)

2-8.5 JP3: LAN Controller Select (for 75FRV-L only)

JP3 is designed to enable/disable the
onboard LAN Controller. To enable the
LAN Controller, users should set JP3 1-2
closed. For an additional LAN channel,
users can insert another PCI LAN card to
onboard PCI slot.
Setting JP3 2-3 closed will disable the
onboard LAN. Then users must use a PCI
LAN card for networking.
JP2
KB/Mouse/Power Button
1-2 closed
Power on by
1
keyboard / Mouse
2-3 closed (default)
Power on by Power button
1
JP3
LAN Controller Select
(75FRV-L only)
1-2 closed
(default)
1
Onboard LAN Enabled
2-3 closed
1
Onboard LAN Disabled
28